In April 24-27, 2018, CHINAPLAS 2018 Shanghai international rubber and plastic exhibition will be held in Shanghai Hongqiao national convention and exhibition center. The exhibition area is expected to be over 320,000 square meters with 4,000 exhibitors worldwide.
HVR Magnetics Co,. Ltd is also invice exhibition, and it is located in the 5.1U39 booths. Welcome to visit HVR MAG products.
1. Easy to Install
No need of manual adjustment when the mold is fixed in the tapping holes or T-slot.
2. Safety
Only used electricity in 1-2 seconds of the MAG and DEMAG phase; no need of electricity during the working,which enables it still in the state of working even power off and would not cause any damage to operators; equipped with safe devices like detection, temperature detection and location detection.
3. High Efficiency
In general, it only takes 3min to change a mold and the time for changing an oversize mold is decreased from 2 hours to 10 min.
4. Maintenance Free
No extra costs on screws, nuts, clamps and other instruments, no distortion to the mold.
5. Simple Operation
Simple and clear operation penal enables any operator with no operating skills can operate independently in one minute.
6. Strong Magnetic Force and Safe Devices
Magnetic force can reach 16kg/c㎡ and will not decrease as time goes.
Work directly with our experienced team to solve your toughest engineering challenges